Assembly instructions for KP Series Downloads

Selection of fastening material:

Material and corrosion resistance:
The choice of material for the fasteners is dependent on the installation environment and operating conditions (e.g. galvanised, stainless steel, etc.), strength grade 4.8 - 8.8

Fastener diameter:
depends on the Cable Clamp (table: metric screw thread [M])

Type of screw:
depends on the substructure (e.g. hexagon screws, T-head screws, etc.); not included in delivery

Fastener Length:
depends on the cable outer diameter and type of substructure

Application with Elastic Inlays:
on-site fixing with any form of adhesive (e.g. glue, silicone or paste) will void the warranty immediately

List of individual components KP Series:

Cable Clamp type Outer diameter of cable Metric screw thread (M) Recommended length of thread*
KP 29/41 29-41 mm M12 113 mm + x
KP 39/53 39-53 mm M12 116 mm + x
KP 51/64 51-64 mm M12 146 mm + x
* For maximum permited outer cable diameter (can be reduced accordingly for smaller diameters)
x corresponds to the height of the substructur

Alternating, tighten nuts with an appropriate torque wrench. Do not use self-securing/self-locking nuts, this prohibits a defined tightening torque.

Only flat washers may be used. No spring or snap rings!

It is essential to respect the specified tightening torques, especially for the upper part, to guarantee perfect and reliable functioning of the cable installation for the long-term.**

** Contact îd-Technik for trailing cables (EPDM, rubber, etc.), please.