Assembly instructions for KH Series Downloads

Selection of fastening material:

Material and corrosion resistance:
The choice of material for the fasteners is dependent on the installation environment and operating conditions (e.g. galvanised, stainless steel, etc.), strength grade 4.8 - 8.8

Fastener diameter:
depends on the Cable Clamp (table: metric screw thread [M])

Type of screw:
depends on the substructure (e.g. hexagon screws, T-head screws, etc.); not included in delivery

Fastener Length:
depends on the cable outer diameter and type of substructure

Application with Elastic Inlays:
on-site fixing with any form of adhesive (e.g. glue, silicone or paste) will void the warranty immediately

List of individual components KH Series:

Cable Clamp type	Outer diameter of cable	Dimension Elastic Inlays	Outer diameter of cable with Elastic Inlays	Metric screw thread (M)	Recommended length of thread*
KH 62/75	62-75 mm	100 x 100 mm	59-72 mm	M16	170 mm + x
KH 73/86	73-86 mm	100 x 100 mm	70-83 mm	M16	175 mm + x
KH 84/97	84-97 mm	100 x 100 mm	81-94 mm	M16	185 mm + x
KH 95/107	95-107 mm	100 x 100 mm	92-104 mm	M16	197 mm + x
KH 105/117	105-117 mm	100 x 100 mm	102-114 mm	M16	210 mm + x
KH 115/140	115-140 mm	150 x 140 mm	112-137 mm	M16	270 mm + x
KH 138/165	138-165 mm	150 x 140 mm	135-162 mm	M18	340 mm + x

* For maximum permited outer cable diameter (can be reduced accordingly for smaller diameters)
x corresponds to the height of the substructur

Alternating, tighten nuts with an appropriate torque wrench. Do not use self-securing/self-locking nuts, this prohibits a defined tightening torque.

Only flat washers may be used. No spring or snap rings!

It is essential to respect the specified tightening torques, especially for the upper part, to guarantee perfect and reliable functioning of the cable installation for the long-term.**

** Contact îd-Technik for trailing cables (EPDM, rubber, etc.), please.