Specification

Application:

Fastening of all types of single- and multi-conductor high and low-voltage cables.

Polyamide, fiberglass-reinforced, coloured black,
flame resistant , special protection against ultraviolet rays,
free of halogenes, fully recycable

Resistance to:	ultraviolet rays, ozone, oils, fuels, alkalis, radioactive rays
Flame resistance:	UL94 V-0 and classification following DIN 5510, part 2, flamability class S3
Thermal expansion:	0,01 % pro 10°C temperature increase
Tensile strength:	120 N/mm²
Flexural strength:	210 N/mm²

The fiberglass-reinforced polyamide used in manufacture is marked by particulary high mechanical strength and heat resistance.
The dynamic forces of high short-circuit currents are very effectively withstood. Implementaion can be done in those cases where high short-circuit currents occur. Therefore a secure fixation of the cables is insured and damage to them is being avoided.
Test reports from neutral laboratories concerning dynamic short-circuit currents, up to 110kA, and the fire-resistance of the material, are available.
As the length of the clamping area is very wide the mechanical pressure on the cable is low.
Implementation both indoor and outdoor due to resistance to ageing, ozone and ultraviolet rays.
No alteration in strength within a temperature range of - 40 °C to 120 °C. Thus particulary suitable for emergency operations of XLPE insulated cables.
Because of its resistance to radioactive rays (at a radiation dose of 100 MRAD strength loss is less than 20%) implementation is also possible in nuclear power stations.
The fastening of cable clamps can be adapted to all local conditions.